After my remote turns on it’s good for few seconds but then just starts beeping for ever.
I have a few questions for you:
- Which remote controller are you using?
- Did you do anything since it last worked as expected (e.g. install new firmware)?
- Does it stop beeping after moving the sticks?
- What does the beeping noise sound like?
I ran into this too:
Google it but the “typical” causes are:
- stick calibration
- low battery
forget the 3rd one
I find that on occasions not plugging a usb cable in until after the rc is booted and connected to the drone first helps at times. I also move the sticks and wheels a couple times before powering on. But as mentioned by DeputyDawg those are generally the reasons.