Perhaps someone can explain this problem. I’m using GS Pro for waypoint missions. Initial settings and starting are done with Go4 App, after that switching to GS Pro. In many cases this is ok, but sometimes I noticed problems.
-
DJI warning zones are too big. One of them is spreading over parts of an official RC modeling ground. Manual Go4 flying is possible, but no GS Pro waypoints
-
Interference issues, signalized in Go4. Manual flying can be done, but no GS Pro waypoints.
-
Strange behavior sometimes in both above situations. Normally I’m using stick mode 2, but then height control in GS Pro moves to right stick (only up), not all movements are accessible. Switching back to Go4 helps out.
Thanks for hints and comments
Walter